[Q90-Q112] 2025 Verified 300-415 dumps Q&As on your CCNP Enterprise Exam Questions Certain Success!

2025 Verified 300-415 dumps Q&As on your CCNP Enterprise Exam Questions Certain Success!

300-415 Exam Dumps - 100% Marks In 300-415 Exam!

Quality of Service and security

Another very important and timely area involves security and the quality of service offered through these products. Thus, this domain goes into detail about how configuring and verifying service insertion is carried out; what application-aware firewalls are; and how to configure QoS treatment in WAN Edge routers and verify such configurations, including the operations such as shaping, scheduling, policing, and queuing. In 300-415, one will face 15% of such tasks.

NEW QUESTION # 90
Drag and drop the attributes from the left that make each transport location unique onto the right. Not all options are used.

Answer:

Explanation:

NEW QUESTION # 91
Which configuration defines the groups of interest before creation of the access list or route map?

Answer: C

NEW QUESTION # 92
Drag and drop the definitions from the left to the configuration on the right.

Answer:

Explanation:

NEW QUESTION # 93
In an AWS cloud, which feature provision WAN Edge routers automatically in Cisco SD-WAN?

A. vAnalytics
B. Cloud app
C. Cloud OnRamp
D. Network Designer

Answer: C

Explanation:

https://www.cisco.com/c/en/us/td/docs/solutions/CVD/SDWAN/cisco-sdwan-design-guide.html

NEW QUESTION # 94
An engineer configures an application-aware routing policy for a group of sites The locations depend on public and private transports The policy does not work as expected when one of the transports does not perform properly This policy is configured:

which configuration completes the policy so that it works for all locations?

Answer: A

NEW QUESTION # 95
In the Cisco SD_WAN solution, vSmart controller is responsible for which two actions? (Choose two.)

A. Authenticate and authorize vEdge routers.
B. Distribute crypto key information among vEdge routers
C. Configure and monitor vEdge routers.
D. Distribute route and policy information via OMP.
E. Distribute the IP address from DHCP server to vEdge routers.

Answer: B,D

Explanation:

NEW QUESTION # 96
Refer to the exhibit.

Which QoS treatment results from this configuration after the access list acl-guest is applied inbound on the vpn1 interface?

A. A UDP packet sourcing from 172.16.20.1 and destined to 172.16.10.1 is accepted
B. A UDP packet souring from 172.16.10.1 and destined to 172.16.20.1 is dropped.
C. A TCP packet sourcing from 172.16.20.1 and destined to 172.16.10.1 is accepted
D. A TCP packet sourcing from 172.16.10.1 and destined to 172.16.20.1 is dropped

Answer: B

NEW QUESTION # 97
Which statement describes the requirement of integrating a secure internet gateway (SIG) with a Cisco SD-WAN Edge device?

A. Based on routing or policy, all customer internet traffic must be forwarded to the SIG.
B. Credentials for a smart account are required.
C. Attached to SIG tunnels, trackers monitor the respective SIG endpoints.
D. A Cisco umbrella organization ID is needed to establish the SIG.

Answer: D

NEW QUESTION # 98
Which component is used to optimize the multicast distribution tree enabled through the multicast network?

A. IGMP client
B. vManage controllers
C. OMP replicator
D. VPN concentrator

Answer: C

Explanation:
The OMP replicator is used in overlay multicast to optimize the multicast distribution tree across the overlay topology.
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/routing/ios-xe-17/routing- book-xe/m-multicast-routing.html

NEW QUESTION # 99
If Smart Account Sync is not used, which Cisco SD-WAN component Is used to upload an authorized serial number file?

A. WAN Edge
B. vSmart
C. vBond
D. vManage

Answer: D

Explanation:
https://sdwan-docs.cisco.com/Product_Documentation/vManage_Help/Release_18.3/Configuration/Devices

NEW QUESTION # 100
Refer to the exhibit

Refer to the exhibit Which command allows traffic through the IPsec tunnel configured in VPN 0?

A. service netsvc1 vpn 1
B. service FW address 1.1.1.1
C. service netsvc1 address 1.1.1.1
D. service local

Answer: B

Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/policies/vedge-20-x/policies-book/service-chaining.html

NEW QUESTION # 101
Which document must you use to verify the NEC standards for a Cisco 8510 Wireless Controller?

A. Safety Guide
B. Hardware Guide
C. Deployment Guide
D. Installation Guide

Answer: D

NEW QUESTION # 102
An engineer modifies a data policy for DIA in VPN 67. The location has two Internet-bound circuits. Only the web browsing traffic must be admitted for DIA. without further discrimination about which transport to use.
Here is the existing data policy configuration:

Which policy configuration sequence meets the requirements?

A. Option D
B. Option A
C. Option B
D. Option C

Answer: B

NEW QUESTION # 103
What do receivers request to join multicast streams in a Cisco SO-WAN network?

A. IGMP membership reports directly with a multicast router.
B. IGMP membership reports directly with the vBond orchestrator.
C. Multicast service routes with the vSmart controller
D. PIM messages with the nearest neighboring multicast router.

Answer: C

Explanation:
In a Cisco SD-WAN network, multicast traffic management is handled differently compared to traditional IP multicast methods due to the nature of the overlay architecture.
* Multicast Service Routes: In Cisco SD-WAN, multicast receivers use the vSmart controller to request multicast streams. This is done via multicast service routes which the vSmart controller manages. The vSmart controller is responsible for maintaining and distributing multicast routing information to all edge devices in the network.
* Process:
* When a multicast receiver wants to join a multicast stream, it sends an IGMP join request.
* The WAN Edge device forwards this request to the vSmart controller.
* The vSmart controller then updates the multicast service routes to include the new receiver, ensuring that multicast traffic is appropriately forwarded to the joining receiver.

NEW QUESTION # 104
Which IP address must be reachable by a WAN Edge device for the ZTP process to work?

A. 10.1.1.1
B. 8.8.8.8
C. 172.16.1.1
D. 4.4.4.4

Answer: D

NEW QUESTION # 105
Which control policy assigned to Drenches in the out direction establishes a strict hub-and-spoke topology tor VPN2?

Answer: A

Explanation:
To establish a strict hub-and-spoke topology in Cisco SD-WAN for a specific VPN, such as VPN2, a control policy must be configured. This control policy dictates how traffic flows between sites, ensuring that all branch traffic is routed through the hub site.
Control Policy Components:
Site Lists: Define which sites are considered hubs and which are branches.
VPN Lists: Identify the VPNs to which the policy applies.
Control Policy: Use sequences to match routes and specify actions to accept or reject traffic based on the defined topology.
Policy Analysis:
Option A: Correctly defines site lists for hub sites (site-id 1-2) and creates a control policy that matches routes for VPN2, accepting routes from hub sites and rejecting routes from others. This ensures that traffic from branches (other sites) is only accepted if it routes through the hubs.
Other options either incorrectly define the site lists or do not properly match and set the routes to enforce the strict hub-and-spoke topology.
Policy Configuration:
policy
lists
vpn-list VPN2
vpn 2
site-list hub_sites
site-id 1-2
!
control-policy vpn_multi_topology
sequence 10
match route
site-list hub_sites
vpn-list VPN2
!
action accept
!
sequence 20
match route
vpn-list VPN2
!
action reject
!
default-action accept
:
Cisco SD-WAN Control Policy Configuration Guide
Cisco SD-WAN Hub-and-Spoke Topology Deployment Guide

NEW QUESTION # 106
An enterprise needs DIA on some of its branches with a common location ID: A041:B70C: D78E::18 Which WAN Edge configuration meets the requirement?
A)

B)

C)

D)

A. Option D
B. Option B
C. Option A
D. Option C

Answer: D

NEW QUESTION # 107
An engineer wants to change the configuration of the certificate authorization mode from manual to automated. Which GUI selection will accomplish this?

A. Tools > Operational Commands
B. Administration > Settings
C. Maintenance > Security
D. Configuration > Certificates

Answer: D

NEW QUESTION # 108
Drag and drop the REST API calls from the left onto the functions on the right.

Answer:

Explanation:

NEW QUESTION # 109
Drag and drop the devices from the left into order on the right to upgrade the software from version 19 to version 20.

Answer:

Explanation:

NEW QUESTION # 110
A WAN Edge device has several service VPNs with no routing protocol configured in the service VPNs. The device must be configured so that all connected routes are visible in OMP for VPN 10.
Which configuration meets the requirement?

Answer: C

NEW QUESTION # 111
Refer to the exhibit.

Customer XYZ cannot provison dual connectivity on both Its routers due to budget constratnts but wants to use tnth RI and R2 interface for users behind them for load toward the hub site Which configurauon achieves this objectives?